Instruction manual

5
Emptying the Water Container
When the water container is full the water full
indicator light will illuminate and the unit will
automatically shut off. Wait a few minutes to
allow the water to finish draining into the
water container. To remove the water container,
pull the lower front panel forward. Pull out and lift the
water tank by the handle and carry it away for
emptying. Gently replace the container and close the
lower front panel. When the tank is properly inserted
both the hole and the float mechanism in the container
will be located directly beneath the drainage spout
and the water full indicator light will go out.
Continuous Drainage Option
This unit can alternatively be used with a con
-
tinuous drainage hose as follows:
• Remove the water container from the unit.
• Pull the funnel selector to the continuous
drainage position A as shown in fig 1. It
should be pulled forward and clicked into
position. This avoids any leakage.
• Pull out the water stopper at the back of
the water unit (fig 2) and insert a 6mm diam
eter (1.5mm thick) hose over the spout.
• Place the other end of the hose in a drain,
ensuring that it is not twisted or folded.
• The pipe must be positioned so that there is
a gradual downward slope from the connec
tion point to the drain.
• Ensure that the outlet of the drainage pipe is
not under the water level in the drain.
• Replace the water container.
Note: In very cold weather conditions precau
-
tions should be taken to prevent the drainage
pipe from freezing.
To return to water tank use, push the funnel se
-
lector to position B (fig 1) and reinsert the water
stopper (fig 2).
Insert hose here
Cabel tidy
Water stopper