Instruction manual

GB

IMPORTANT!
• The unit is designed for indoor operation.
• Rating: This unit must be connected to a 220-240 V / 50 Hz earthed outlet.
• The installation must be in accordance with regulations of the country where the
unit is used.
If you are in any doubt about the electrical installation, have it checked and if
necessary modied by a qualied electrician.
• Unplug when not in use. Do not unplug by pulling the cord.
• Do not operate this product with wet hands.
• Keep out of the reach of children.
• Do not clean the unit by spraying it or immersing it in water.
• Disconnect it from the mains before cleaning the unit or any of its components.
• Always unplug before changing the carbon lter.
• Do not connect the unit to an electrical outlet using an extension cord. If an
outlet is not available, one should be installed by a licensed electrician.
• Keep at least 20cm distance from the wind outlet to the combustible surfaces,
when the heater is on.
Do not use your PLDA under the following conditions:
Close to a heat
source
Inside unit exposed
to the weather
outdoors
In a permanent
very humid
environment
If the power cable
wires are frayed
or cut
When small
children may be
left unattended
If an extension
cord is needed to
reach an outlet
Where the power
cable may be
damaged
On a slope or
uneven surface
Where it may
be damaged by
chemicals
Where there is a
risk of interference
by foreign objects
This product is
not made for DIY
repair
If there is a risk of
liquid falling on
the unit
Fan
Motor
Proximity
switch
Water tank
Micro switch
Condenser
(warmed coil)
Evaporator
(cold refrigerated coil)
Buoy
Compressor
Door switch
Proximity
switch
Water tank
Moist
air
Moist ai
r
Warmer dry air
a
b
c
d
e
f