User Manual
Page 9 of 15
POWER ON/OFF (7)
· Press the POWER button to turn the unit On or Off
· When turned on the unit will be set to cooling mode with a desired temperature of 22
o
C.
· Press the POWER button again and the unit will turn off.
MODE BUTTON (6)
· Press this button to change between Cooling, Fan, Sleep or Dehumidifying Modes.
COOLING MODE
Cold air is expelled through the front of the unit and hot air is expelled through the vent hose.
When the machine is turned on, it will enter cooling mode with a desired temperature of 22ºC and
low fan speed.
If the unit is not in cooling mode, press the MODE button to select cooling mode, the cooling
mode indictor will be illuminated.
Press the UP and DOWN buttons to adjust the desired temperature
(Between 16ºC and 31ºC)
Press the FAN button to change between the fan speeds (low or high)
FAN MODE
No heating or cooling, air is recirculated.
Press the “MODE” button to select the fan mode, the fan mode indicator (D) will illuminate.
DEHUMIDIFY MODE
The unit should be set up without a vent hose, moisture is extracted from the air that passes through
the unit. Continuous drainage should be set up for the moisture collected (Drainage pipe not
included)
Press “MODE” to select dehumidify mode, the dehumidifying mode indicator will illuminate
When using dehumidify mode the sleep function cannot be used and the fan speed is low.
TIMER
Timer functions cannot be combined or repeated.
POWER ON TIMER
With the appliance is turned off, press the “TIMER” button to setup the power-on time. Press
the UP and DOWN buttons to adjust the duration of the timer (from 1 to 24 hours). The timer
indicator will turn on. The unit will start after selected number of hours.
POWER OFF TIMER
With the appliance running with the desired settings, press the “TIMER” button to setup the
power-off timer. Press the UP and DOWN buttons to adjust the duration of the timer (from 1 to
24 hours). The timer indicator will illuminate. The unit will stop after selected number of hours.
SLEEP MODE
While the sleep mode is activated in cooling mode, after one hour the desired temperature will be
increased by 1ºC, after another hour the desired temperature will increase by another 1ºC and
remain at that level. This means the unit will spend less time with the compressor running, and so
run quieter.
Press the MODE button until the sleep mode indicator is illuminated, the fan speed is set to
low.
Sleep mode cannot be used in dehumidifying and fan mode.
If the internal tank becomes full, the machine will turn off and sleep mode will be cancelled.