Q-2411 PRO Professional Preamp Mixer User Guide and Reference Manual 12/06 4295 Charter Street Los Angeles Ca. 90058 www.AmericanAudio.
Q-2411 PRO CONTENTS MAIN FEATURES....................................................................................................................................2 ELECTRICAL PRECAUTIONS...............................................................................................................4 SAFETY PRECAUTIONS.......................................................................................................................5 INTRODUCTION.........................................................
Q-2411 PRO ELECTRICAL SAFETY PRECAUTIONS WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN, LIQUIDS, OR MOISTURE CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER TYPE OF ELECTRICAL OUTLET UNLESS THE WIDE BLADES CAN BE CAREFULLY INSERTED INTO A MATCHING WIDE SLOT.
Q-2411 PRO ELECTRICAL SAFETY PRECAUTIONS ELECTRICAL PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK).
Q-2411 PRO SAFETY PRECAUTIONS 1. For adult use only - Keep out of the reach of children. 2. Water and Moisture - The player should not be used near water - for example, near a bath tub, kitchen sink, laundry tub, in a wet basement or near a swimming pool, etc. Do not spill water or other liquids in to or on to your mixer. 3. Ventilation - The Mixer should be situated so that its location or position does not interfere with its proper ventilation.
Q-2411 PRO INTRODUCTION Introductions: Congratulations and thank you for purchasing the American Audio® Q-2411 PRO mixer. This mixer is a representation of American Audio’s continuing commitment to produce the best and highest quality audio products possible at an affordable price. Please read and understand this manual completely before attempting to operate your new mixer. Please carefully read and understand the instructions in this manual thoroughly before attempting to operate this unit.
Q-2411 PRO UNPACKING Every Q-2411 PRO has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your mixer for any damage and be sure all equipment necessary to operate the mixer has arrived intact. In the event damage has been found or parts are missing, please contact our toll free customer support number for further instructions.
Q-2411 PRO FRONT PANEL - CONTROLS AND FUNCTIONS 1 20 2 19 18 17 3 4 5 16 15 14 13 6 12 11 10 7 9 8 1. MICROPHONE 1 - This combo jack will accept a standard 1/4 plug or XLR 3-pin balanced male plug. The volume output level for this microphone will be controlled by its own respective CHANNEL KNOB (20). Note: We recommend that you use a 500-600ohm microphone for the best sound quality. 2.
Q-2411 PRO FRONT PANEL - CONTROLS AND FUNCTIONS CONT. each channel. Each channel may only be assigned one input source at a time. This switch must be in the “phono” position for turntable operation. 5. MASTER OUTPUT BALANCE CONTROL - This knob is used to control the pan, adjust how much of the signal is sent to the left and right output level. For true stereo imaging, maintain the knob in the 12 o’ clock position. 6. POWER SWITCH - This is the main power ON/OFF button.
Q-2411 PRO FRONT PANEL - CONTROLS AND FUNCTIONS CONT. For example; Assuming you have two compatible American Audio™ CD players or a compatible dual CD player connected to channels one and two. When the Fader "Q" Start option is turned on, sliding the crossfader to the far left position will trigger playback on CD player 1. When the crossfader is pushed to the far right position, playback on CD player 2 will begin, and CD player 1 will return to the cue position.
Q-2411 PRO REAR PANEL - CONTROLS AND FUNCTIONS 21 22 34 33 32 31 30 29 28 27 24 26 24 25 24 23 21. GND (GROUND TERMINAL) - Be sure to connect turntable ground leads to either or both of the two available ground terminals. This will reduce the humming and popping noises associated with magnetic phono cartridges. 22. MIC ATTENUATOR - This knob is used to adjust the MIC 1 and MIC 2 input level. 23. MICROPHONE 2 CONNECTOR - This jack is used to a connect a microphone to the mixer.
Q-2411 PRO REAR PANEL - CONTROLS AND FUNCTIONS CONT. decks, etc.) to these jacks when the LINE LEVEL SELECTOR SWITCH (24) is in the “PHONO 2” position, THIS MAY SERIOUSLY DAMAGE YOUR MIXER! The red colored RCA jack represents the right channel input and the white represents the left channel input. Input volume will be controlled by the channel two fader. The channel SOURCE SELECTOR SWITCH (4) must be in the "Phono 2/Aux 2" position, to monitor any source connected to these jacks.
Q-2411 PRO REAR PANEL - CONTROLS AND FUNCTIONS CONT. 31. PLAYER CONTROL PLAYER 1 CONTROL - This jack is used to control the “Q-Start” function between the mixer and a compatible American Audio® or American DJ® CD Player. Using the mini plug included with your CD player, connect from the CD player controller out jack to this jack. Player A “Q-Start” functionallity will be controlled by the left side of the CROSSFADER (16).
Q-2411 PRO TYPICAL MIXER SET-UP CASSETTE DECK T U R N TA B L E This image details a typical DJ Set Up consisting of a microphone, turntables, CD players, and a tape deck. Note: Turntables can only be connected to the PHONO LEVEL RCA JACKS. Be sure the LINE LEVEL SELECTOR SWITCHES are in the "PHONO" position when using turntables. ©American T U R N TA B L E Audio® - www.americanaudio.
Q-2411 PRO TYPICAL MIXER SET-UP RCA to RCA Patch Cables Balanced XLR male to XLR female Cables CASSETTE DECK American Audio V4001™ Speaker Cables Typical Balanced Output Set-up This image details a typical stereo output layout. Note the use of the Balanced XLR Jacks on both the mixer and the amplifier. Always use the balanced output jacks whenever possible. The balanced output jacks should always be used for cable runs in excess of 15 feet.
Q-2411 PRO CLEANING Due to fog residue, smoke, and dust, cleaning the mixer should be carried out periodically to residue build up. 1. Use normal glass cleaner and a soft cloth to wipe down the outside casing. 2. Use a cleaner specially designed for electronics to spray in and around the knobs and switch. This will reduce small particle built up that can effect the proper operation of the mixer. 3. Cleaning should be carried out every 30-60 days to prevent heavy built up. 4.
Q-2411 PRO TROUBLESHOOTING Trouble Shooting: Listed below are common problems you may encounter, and solutions. There is no power to the unit: 1. Be sure you have connected the power cord to a correct wall outlet. There is little or no sound: 1. Check the input selector switch. Make sure it is set to the device that is currently playing. 2. Check to see if the connection cables are connected properly. The sound is distorted: 1. Make sure that the Gain level control is not set to high.
Q-2411 PRO WARRANTY The Q-2411 PRO carries a one year limited warranty. We recommend you fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must be freight pre-paid and accompany a R.A. (return authorization) number. If the mixer is under warranty, you must provide a proof of purchase invoice. You may obtain a R.A. number by contacting our customer support team on our toll free number.
Q-2411 PRO SPECIFICATIONS Model: Q-2411 4 Channel Mixer POWER SUPPLY: AC 115v~60Hz/230v~50Hz, User Selectable Single Voltage: AC 100V, 50/60Hz (Japan) AC 110V, 60Hz (Colombia) AC 120V, 60Hz (U.S.A. and Canada) AC 127V, 60Hz (Mexico) AC 220V, 50Hz (Chile and Argentina) AC 220V, 60Hz (Philippines and Korea) AC 230V, 50Hz (Europe, U.K., New Zealand, South Africa, and Singapore) AC 240V, 50Hz (Australia) DIMENSIONS: 482.6mm (W) x 177mm (D) x 97mm (H) 19” (W) x 6.96” (D) x 3.8” (H) 6.6 Lbs. / 3.0Kgs.
©American Audio® World Headquarters: 4295 Charter Street Los Angeles, CA 90058 USA Tel: 323-582-3322 Fax: 323-582-2941 Web: www.americanaudio.us E-mail: info@americandj.