Installation Guide

6
PAN & WALL THRESHOLD TRIM
TIME REQUIRED
1/2 - 1 HR
8
diagram 10
diagram 11
cement
board
diagram 9
diagram 6
diagram 8
metal pan
Threshold Door
A - Pan Threshold
1. Locate the threshold pieces (diagram 6) (diagram 7)
2. Dry fit thresholds onto the front of the metal pan. The Door threshold does not have a channel in it.
The door rail is reversible and can be placed on the left or right. (diagram 8)
3. Remove and place 100% RTV silicone in the Pan where the bottom of thresholds rest, and in
the bottom channels under the thresholds, re-install thresholds into pan sitting level.
4. There will be a small gap between the bottom of thresholds and the floor, this can be
grouted later if it is still exposed after installing bathroom flooring.
B - Glass Door and Glass Panel Casing Trim
1. Locate Glass door side casing.
2. Locate glass panel channel side casing & cap. (diagrm 9)
2. To help with the side casing installation, use a level and draw a plumb line from the inside of
the pan threshold up to the top of the shower. Do this on both sides. This line will be where
the side casings and the wall Panels meet, this will give you a visual reference point when
dry-fitting your wall panels.
3. Apply 100% RTV silicone, using a circular pattern, to the cement board along the plumb line,
approximately 4 inches wide, to the edge of the shower pan. (diagram 10)
4. Place the first side Casing into position, making sure to align the side rail with the vertical
plumb line previously drawn on the cement board. Apply pressure to the side casing to bond
it to the cement board. The side casing will be flush with the inside of the shower pan threshold
and have a small gap where the pan threshold slopes. (diagram 11)
5. Place the remaining side casings into position, 3 to each side and cap. Make sure to use a level
and the plumb line previously drawn on the cement board to align the side casings vertically.
silicone
TD
P
diagram 7
metal pan
threshold panel
silicone
TP
P
TD TP
TD
metal pan
P
threshold door
TD
Threshold Panel
TP
Door side Casings (3)
& Cap
panel channel side
Casings (3) & Cap
CD
CP
CD
CP
silicone-
circles
TP
(reversible)