Instructions / Assembly

Transparency to
create outlines
Use masonry screw when fastening
directly into masonry or through a buck
into masonry.
Remove or cut ventilation holes in
plastic shipping wrap if door is not
installed immediately or product
damage may occur.
Weep holes must face the exterior
and must be located at the bottom of
the door or product and/or property
damage may occur.
Do not drill into or through the sill of
the door or product and/or property
damage may occur.
Do not store doors at or in the sun or
product damage may occur.
Buildings constructed prior to 1978
may contain lead paint which could be
disturbed during replacement. For more
information on proper management of
lead paint, visit www.epa.gov/lead
Carefully remove fasteners that attach
wood to door. Fastener holes are used
for installation. Failure to do so could
result in product damage.
Important safety information. Leave
this information for the building
occupant.
Do not apply any type of lm to glass.
Thermal stress conditions resulting in
glass damage could occur.
When insulating between unit frame
and rough opening or between units
when joining, DO NOT overpack
batt insulation or overll with foam.
Bowed jambs will result affecting
product performance and/or proper
operation of unit.
Do not overll with low expanding
foam or overpack with backer rod to
avoid bowed jambs.
Warnings and Cautions:
Installation Guide
Assembled 2-Panel Patio Door
5
888-504-0005www.AmericanCraftsmanWindows.com