Full Product Manual
ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 11
Dotz TPar System System Menu
Pixel Flip - In this mode you adjust the unit so that the
LEDs in DMX mode will illuminate at your desired starting
point. The unit can start at either the left or the right.
1. Press the MENU button until “Pixel Flip” is displayed, press
ENTER.
2. Either “O” or “On” will be displayed. “O” the unit will illumi-
nate left to right, and “On” the unit will illuminate right to left. Use
the UP and DOWN buttons to nd your desired mode, and press
ENTER.
RF Active - This menu will let you activate the RF remote
control.
1. Press the MENU button until “RF Active” is displayed, press
ENTER.
2. Either “On” or “O” will be displayed, use the UP or DOWN
buttons to activate (On) or deactivate (O) the remote. Press
ENTER to conrm.
ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 10
Universal DMX Control: This function allows you to use a Elation®
universal DMX-512 controller to control the chases and patterns,
dimmer and strobe. A DMX controller allows you to create unique
programs tailored to your individual needs. The Dotz TPar System
has 5 DMX channel modes; a 3 Channel Mode, 5 Channel Mode, 9
Channel Mode, 12 Channel Mode, & 18 Channel Mode. See pages
14-20 for the DMX channel modes and traits.
1. This function will allow you to control each individual fixture’s
traits with a standard DMX 512 controller such as the
Elation® Show Designer™ or the Elation® DMX Operator.™
2. To run your fixture in DMX mode, follow directions on page 8 to
set your DMX address and DMX Channel mode.
3. Plug in the fixture via the XLR connections to any standard DMX
controller.
4. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
Dotz TPar System Universal DMX Control
Master-Slave Operation: This function will allow you to link up to 16
units together and operate without a controller. The units will be sound
activated. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units programs. Any unit
can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units together
via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector is
the output. The rst unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit, designate the unit as a “Master” unit following
the instructions on page 10. Then set your desired operating mode.
3. On the slave units press the MODE button until “Slave Mode” is
displayed.
4. The slave units will now follow the Master unit.
Dotz TPar System Master-Slave Configuration