Full Product Manual

ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 13
ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 12
Dotz TPar System Foot Controller
The Foot Controller has 4 different functions. To control your fix-
ture you must connect the foot controller using the provided cable.
Set the Dotz TPar System to its “Slave” setting. Connect one end
of the cable to the foot controller and the other end to the rear of
the Dotz TPar System bar. To activate the Foot Controller press any
pedal once. To deactivate the Foot Controller press the Blackout and
Program pedals at the same time.
BLACKOUT - Pressing this button will blackout the fixture. Press the
pedal for more then 3 seconds to activate Full On.
MODE - This pedal selects and activates the 3 different operating
modes. Press the pedal for more then 3 seconds to activate Full On.
• Press the MODE pedal and the Red LED lights up, you are Static
Color mode. Use the UP and DOWN pedals to scroll through the 7
different colors.
• Press the MODE pedal and the Green LED lights up, you are in
Sound Active mode. Adjust the sound sensitivity using the knob on
the rear panel of the foot controller.
• Press the MODE pedal and the Yellow LED lights up, you are in the
Built-In Programs mode. Use the UP and DOWN pedals to scroll
through the 14 different programs. Refer to the chart on page 7 for
the programs.
UP - This pedal works in conjunction with the MODE pedal, it lets
you scroll through the static colors and built-in programs. Press the
UP pedal for more then 3 seconds to activate connected light 1 (right
side of the bar). Press the pedal for more then 3 seconds to deacti-
vate light 1.
DOWN - This pedal works in conjunction with the MODE pedal, it lets
you scroll through the static colors and built-in programs. Press the
DOWN pedal for more then 3 seconds to activate connected light 2
(left side of the bar). Press the pedal for more then 3 seconds to de-
activate light 2.
Dotz TPar System Dotz RF Remote
The Dotz RF remote has many different functions and allows you to
control your Dotz TPar System from long distance. The remote can
control your system up to 25 meters. To use the remote you must first
activate the fixtures receiver, to activate the receiver please see the
instructions on page 11.
BLACKOUT - Pressing this button will blackout the fixture.
FADE - This button will activate the color fade program.
COLOR - This button will activate the static color mode. Use the “+”
and “-” buttons to scroll through the colors and find your desired
color.
PROGRAMS - This button will activate the built-in programs mode.
Use the “+” and “-” buttons to scroll through programs 2-14 to find
your desired program.
LIGHT 1 ON - This button will activate any light that is installed on the
top of the bar and connected to the first light connection (right side of
the bar).
LIGHT 1 OFF - This button will deactivate any light that is installed
on the top of the bar and connected to the first light connection (right
side of the bar).
LIGHT 2 ON - This button will activate any light that is installed on the
top of the bar and connected to the second light connection (left side
of the bar).
LIGHT 2 OFF - This button will deactivate any light that is installed on
the top of the bar and connected to the second light connection (left
side of the bar).
SOUND ACTIVE - This button activates sound active mode.
AUTO RUN - This button will run an automatic program. Use the “+”
and “-” buttons to adjust the speed of the auto run.
“+” and “-” - Use these buttons to adjust the speed of the Auto Run,
scroll through the built-in programs, and scroll through the static col-
ors.