Specifications

Installing Hardware
16 Intellex®
Rack Mounting the System
The Intellex rack-mounting chassis has pre-drilled holes to install the included rack slides. Mount
the unit by attaching rack slides to the chassis and using the included front mount rack holes.
Ensuring Proper Rack Mounting
Consult with the supplier of your equipment rack for adequate rack mounting for the unit’s weight,
for the proper hardware, and for the procedure for mounting this product safely and usably. Avoid
uneven loading or mechanical instability.
Caution
You must mount the unit in a fully supported rack. Use rails rated for a minimum of 150 pounds that
attach to both sides of the unit and to the front and back of the rack. The rack must be equipped with EIA-
310-D standard 19-inch front and rear mounting flanges.
Safety Guidelines
Ensure adequate air flow around the unit for safe operation. The maximum temperature for rack-
mounted units is 35° C.
Check the product label for power supply requirements to assure that no overloading of supply
circuits or overcurrent protection occurs. Mains grounding must be reliable and uncompromised by
any connections.
Use an uninterruptible power supply (UPS) as standard practice to protect computing systems
from power fluctuations that may cause data loss.
Miscellaneous Parts
Manuals CD; Quick Setup Guide; S-Video to RCA Adapter; RCA-BNC Adapter; BNC Terminator;
USB/RS-232 Adapter (Premier model only); Network Client.
Note
Connect the Composite Video Output connector to a properly terminated device (monitor, VCR or
75
Ω load) or to a 75 Ω terminator during system startup to enable composite output. If a load is not
present on the composite output, a video signal is not sent to the composite output. You must
connect a terminated device or the BNC terminator then reset the unit.
S-Video to RCA Adapter Use to access the PAL or NTSC Composite Video Output of the VGA card.
Connect it to the S-Video DIN style connector.
RCA-BNC Adapter Use to attach a monitor or recording device (VCR) that requires a BNC
connector to the Composite Video Output connector on the S-Video to
RCA Adapter.
BNC Terminator Use to terminate the signal from the Composite Video Output connector
on the rear panel.
USB/232 Adapter Use to record a single text stream. Connect to one of the USB ports on the
back of the Intellex. Reboot the unit after installation and before setting up
the text stream in Intellex.