Operating instructions

• Pull the red handle and remove the screen, or;
• Lift the red latch to release the window.
Slide it completely through the slot so the
window swings free.
When parked, be sure the exit window is not
blocked by trees or other obstacles.
REMOTE MIRROR CONTROL
(If Equipped)
Your new motor home may be equipped with
the optional power mirror. The driver's control
panel also contains controls for the exterior rear
view mirror adjustment and heater,
if equipped.
To adjust the mirrors, select either LEFT or
RIGHT mirror and press the appropriate arrow.
Activate the mirror heaters by pressing the
HEATER control.
In the event the power mirror option was
not'
selected and added, manual adjustment of the
mirrors is required to provide a view
of the sides
and rear
of the motor home.
SUN VISORS
Sun visors at the driver and passenger positions
swing down and are adjustable to provide relief
from glare and
blight sun. Your motor home may
also be equipped with side shades mounted on the
side windows that can be adjusted to suit driving
conditions.
Swivel tension may be adjusted with a
screwdriver at the tension adjusting screw.
WINDOW SHADES (If Equipped)
To raise blinds or shades:
Release bottom of blind from retainer.
Pull straight down on cord and release at
desired height.
It is not necessary to pull the cord to one
side or the other to secure blind.
Living With Your Motor Home
To lower:
Pull straight down on the cord slightly, and
move it about
45 degrees to either the left
or right and lower the blind.
Stop the blind in mid-travel by moving it
back to the straight down position.
Reattach the retainers when traveling.
To adjust the angle, turn the adjusting rod
either direction.
Day/Night Shades (If Equipped)
The day/night shades are dual-purpose window
covering that provide privacy at night and light
control during the
day.
To operate them, pull down on the lower bar to
expose the sheer fabric for daytime light control.
For use at night, pull
on the npper bar to unfold
the privacy curtain.
MINI-BLINDS (If Equipped)
To raise mini-blinds:
Release bottom of blind from retainer. Pull
straight down on cord and release at desired
height. It is not necessary to pull the cord to
one side or the other to secure blind.
To lower mini-blinds:
Pull straight down on the cord slightly, and
mo:ve it about 45 degrees to either the left
or right and lower the blind. Stop the blind
06-3