Operator`s manual

SECTION 9. OPERATION

Form 169006 103 Revision D

c. Re-position right arm cylinder (Double Reel) as

follows:

1. Remove bolts (H) that secure plate (J), and

remove plate.

2. Remove bolts (K) so that front plate (L) is

free to move up.

3. Lift the aft end of the cylinder out of support

assembly, and move the cylinder so that

cylinder center port fitting (T) engages the

support assembly.

NOTE

Loosen a hose fitting to allow

movement of cylinder. Be sure to

re-tighten fitting after cylinder

installation.

4. Re-install plates (J) and (L) with bolts (H) and

(K) respectively.

d. Re-position right arm cylinder (Single Reel) as

follows:

1. Remove bolt and nut (M), and four bolts (N)

securing hose shield (O).

2. Move hose shield and hoses away from

cylinder.

3. Remove bolts (P) that secure aft plate (Q),

and remove the plate.

4. Remove bolts (R) so that front plate (S) is

free to move up.

(continued next page)

RIGHT

ARM

SHOWN

RIGHT ARM - DOUBLE REEL

RIGHT ARM - SINGLE REEL