Operator`s manual

SECTION 9. OPERATION
Form 169006 104 Revision D
5. Lift aft end of the cylinder out of the support
assembly, and move cylinder so that cylinder
center port fitting (U) engages the support
assembly.
NOTE
Loosen a hose fitting to allow
movement of cylinder. Be sure to
re-tighten fitting after cylinder
installation.
6. Re-install plates (S) and (Q) with bolts (R)
and (P) respectively.
7. Re-position hoses, and re-install shield (O)
with bolts (N).
8. Position hoses inside shield, and install bolt
(M) and nut.
e. Re-position left arm cylinder (Double and Single
Reel) as follows:
1. Loosen fitting (A) to allow it to rotate when
cylinder is re-positioned.
2. Remove the bolt (B), nut, and spacer (C) that
secures the cylinder to the reel arm.
3. Extend cylinder so that mounting hole lines
up with new location (D) as shown.
4. Re-install bolt (B) and nut with spacer (C).
5. Tighten fitting (A).
f. Check reel clearance to back sheet, upper cross
auger (if installed) and reel braces.
g. Adjust reel tine pitch if required. Refer to Section
9.11.11 Reel Tine Pitch, or Section 10.14.1 (D50,
D60) or 10.14.2 (FD70) Reel Clearance to
Cutterbar for adjustment procedures.
R
U
S
Q
RIGHT ARM - SINGLE REEL
M
O
N
Q
P
LEFT ARM - SINGLE and DOUBLE REEL
D
A
C
B