Operator`s manual

SECTION 9. OPERATION

Form 169006 109 Revision D

D50

a. Open endshield.

b. Remove from storage.

c. Position crop divider as shown by locating lugs

(B) in holes in endsheet.

d. Lift forward end of divider, and install bolt (A),

lock-washer, and flat washer. Tighten bolt.

e. Check that divider does not move laterally.

Adjust bolts (C) as required to tighten divider and

remove lateral play when pulling at divider tip.

f. Close endshield.

9.11.12.5 Rice Dividers

Optional special rice dividers can be installed and

used when required. See Section 12.15 RICE

DIVIDER KIT.

The installation and removal procedures are the

same as for the standard crop dividers.