Operator`s manual

SECTION 9. OPERATION
Form 169006 119 Revision D
9.18.3.2 Rear Wheels To Field Position
a. Pull pin (A) at left wheel, swivel wheel clockwise,
and lock with pin (A).
b. Remove pin at (B). Store pin at (C) as shown.
c. Pull handle (D) to release.
d. Lift wheel to desired height, and engage support
channel into slot (E) in upper support.
e. Push down on handle (D) to lock.
f. At right cutterbar wheel, pull pin (F) on brace (G),
disengage brace from cutterbar, and lower the
brace against axle (H).
g. Remove pin (J), lower the support (K) onto axle,
and re-insert pin into support.
h. Swing axle clockwise to rear of header.
i. Pull pin (L) at right wheel, swivel wheel counter
clockwise to position shown, and lock with pin.
j. Remove hairpin (M) from latch (N).
k. Lift wheel, lift latch (N), and engage lug (O) onto
left axle. Ensure latch closes.
l. Secure latch with hairpin (M).
(continued next page)
TRANSPORT TO FIELD - LH WHEEL
Release
Lock
C
D
E
B
TRANSPORT TO FIELD - LH WHEEL
A
TRANSPORT TO FIELD - RH SIDE
L
O
M
N
TRANSPORT TO FIELD - RH WHEEL
K
J
H
G
F