Operator`s manual

SECTION 9. OPERATION

Form 169006 125 Revision D

h. Tighten straps until float limiter bars (J) are

loose. Remove pins (K) at lower end of bars.

NOTE

Float limiter bars are stamped with

letter F.

i. Loosen two bolts (L) attaching feed auger to drive

shaft.

j. Disconnect hoses (M) at feed draper motor, and

re-connect ends with a 5/8 inch JIC male to male

fitting (shown in previous column).

NOTE

Mark hoses so that they are re-installed

in the matching ports when re-installing

the feed deck. Install plugs on motor

ports.

k. Loosen two bolts (N) that secure deck retaining

pins (O). There is one bolt per side.

l. Remove pins (O), and pull feed deck away.

Replace pins for re-installation.