Operator`s manual

SECTION 9. OPERATION
Form 169006 126 Revision D
D
9.19.1.2 Auger and Transition Pan Removal
a. Remove four bolts (A) that attach auger right
hand support to adapter frame.
b. Move auger to the right to allow auger left hand
support to slide off auger drive shaft tube.
c. Remove auger, and set aside for re-installation.
d. Remove four bolts (B) securing transition pan (C)
to the cutterbar.
e. Pull transition pan away from cutterbar so that it
slides off header legs. Set aside for
re-installation.
f. Re-install inboard float
springs (D).
Tighten adjuster bolt
until tension is
approximately that of
the adjacent spring.
Tension will be
adjusted after header
deck is shifted, and
header is re-attached
to the combine.
9.19.1.3 Re-Position Deck
a. Loosen bolt (E) on deck that is to be moved.
b. Slide deck to close off center opening. Re-tighten
bolt (E).
c. Reverse draper drive motor hoses (F) on moved
deck so that draper turns the same direction as
existing deck. (Right deck motor hoses (F) shown
on next page).
(continued next page)
A
B
C
E
LEFT DECK MOTOR
F