Operator`s manual

SECTION 9. OPERATION

Form 169006 127 Revision D

NOTE

If right deck is moved, loosen clamp on

plastic sleeve at right deck drive motor

so that hoses can be reversed.

Re-tighten clamp.

IMPORTANT

The deck on 45 FT header needs to be

supported at front when re-positioning,

and requires installation of an additional

deck support.

d. Install support as follows:

1. Remove support (G) from backsheet, and

remove hardware from support. Retain

hardware.

2. Install support on lift cylinder bracket at

center of backtube with bolt and nut. Do not

tighten.

3. After deck is moved, attach backsheet to

support (G) with hardware provided.

4. Tighten bolts.

9.19.1.4 Header Attachment

a. Re-attach adapter to combine. Refer to Section 7

HEADER ATTACHMENT/DETACHMENT.

b. Re-attach header to adapter. Refer to Section 8

HEADER/ADAPTER DISASSEMBLY AND

ASSEMBLY.

c. Adjust header float. Refer to Section 9.11.3

Header Float.

d. Level header if necessary. Refer to Section 9.14

HEADER LEVELLING.

RIGHT DECK MOTOR