Operator`s manual

SECTION 10. MAINTENANCE AND SERVICING

Form 169006 138 Revision D

e. To achieve a snug fit between aft end of shield

and header frame, loosen bolts (F), and adjust

latch (G) to re-position shield.

f. Tighten bolts (F).

10.4.2 Linkage Cover (FD70

FLEXDRAPER ONLY)

a. To remove balance linkage covers (A), remove

screw (B), and lift outboard end of cover.

b. Rotate upward until inboard end can be lifted off.

c. To install the cover, locate inboard end over

linkage and behind indicator bar (C).

d. Lower cover until secure and against the header

tube.

e. Install screw (B).