Operator`s manual

SECTION 10. MAINTENANCE AND SERVICING
Form 169006 156 Revision D
D
E
10.7 ELECTRICAL
a. Use electrical tape and wire clips as required to
prevent wires from dragging or rubbing.
b. Keep lights clean, and replace defective bulbs.
c. To replace light bulbs:
1. Using a Phillips screwdriver, remove screws
from fixture, and remove plastic lens.
2. Replace bulb, and re-install plastic lens and
screws.
NOTE
Bulb Part Number - Trade #1156.
10.8 MAIN DRIVE
10.8.1 Driveline Removal
The main driveline normally remains attached to
the adapter, and is stored on the hook provided
when not in use.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
a. If adapter is attached to combine, remove
driveline from combine by pulling the quick
disconnect collar to release driveline yoke at
combine shaft.
b. Remove two nuts (A) attaching shield (B) to
gearbox.
c. Slide shield over poly driveline shield to expose
quick disconnect on gearbox. Do not
disconnect
tether (C).
d. Pull quick disconnect collar to release driveline
yoke, and pull driveline off shaft.
e. Slide shield (B) off driveline.
f. Rotate disc (D)
on adapter
driveline
storage hook
(E), and
remove
driveline from
hook.
A
B
C