Operator`s manual

SECTION 10. MAINTENANCE AND SERVICING

Form 169006 163 Revision D

10.9.4 Auger Tine Replacement

The CA20 Combine Adapters are fitted with tines

to accommodate a wide variety and sizes of

combines.

Some conditions may require the removal or

addition of tines for optimal feeding of the crop.

In addition, tines that become worn or damaged

should be replaced.

To simplify the procedure, detach header from

combine.

Refer to Section 7 HEADER ATTACHMENT/

DETACHMENT.

10.9.4.1 Tine Removal

a. Remove screws (A), and remove access cover

(B).

b. From inside the auger, remove hairpin (C), and

pull tine (D) out of bushing (E).

c. From inside the auger, swivel tine away from

bushing, pull from plastic guide (F), and remove

from auger.

NOTE

If the sixth tine (D) opposite drive side is

being replaced, it also must be slipped

off drive tube (G). This particular tine

cannot be removed for normal

operation.

d. Remove screws (H) securing plastic guide (F) to

auger, and remove guide from inside auger.

e. Position cover (J) from inside auger over hole,

and secure with screws (K). Coat screws with

Loctite® #243 (or equivalent), and torque to

75 in·lbf (8.5 N·m).