Operator`s manual

SECTION 10. MAINTENANCE AND SERVICING

Form 169006 165 Revision D

10.10 VIBRATION DAMPERS

Worn or damaged vibration dampers will cause

excessive noise and vibration, and it is

recommended they be replaced.

The header and adapter must be detached to

replace the dampers. Refer to Section 8

HEADER/ADAPTER DISASSEMBLY AND

ASSEMBLY.

10.10.1 Rubber Pad Replacement

Secondary Vibration Damper (D50 and D60

Harvest Header only)

a. Remove bolt (A), washer and spacer (B), and

remove secondary vibration damper (C) from

adapter arm.

b. Remove rubber pad (D) from shoe.

c. Place new pad (D) in shoe, and position damper

d. Secure with bolt (A), spacer (B) and washer.

Primary Vibration Damper (D50 and D60 Harvest

Header and FD70 FlexDraper)

a. Remove secondary damper (if applicable). See

previous column).

b. Remove nut (E) and keeper (F) from primary

damper.

c. Slightly compress damper as shown, and remove

pin (G). Remove top half (H). Link (J) will hold

bottom half of damper.

d. Remove worn or damaged rubber pads (K).

e. Position new rubber pads (K) in lower half, and

position upper half (H). Ensure link (J) is

engaged in damper.

f. Slightly compress the two halves so that pin (G)

can be installed.

g. Attach keeper (F), and secure with nut (E).

h. Re-attach secondary damper (if applicable). See

opposite.