Operator`s manual

SECTION 10. MAINTENANCE AND SERVICING
Form 169006 192 Revision D
10.14.1.2 Reel Clearance Adjustment: D50,
D60
DANGER
Engage header lift cylinder stops before
working under header.
a. Raise header, engage header lift cylinder stops,
and lower header onto stops.
b. Lower the reel fully.
c. Adjust outside arms as follows:
1. Loosen bolt (A).
2. Turn cylinder rod (B) counter clockwise to
raise reel and increase clearance to
cutterbar, or clockwise to decrease.
3. Tighten bolt (A).
4. Repeat at opposite side.
d. For double reel (D60 only), adjust center arm as
follows:
1. Loosen nut (C), and turn nut (D) clockwise to
raise reel and increase clearance to
cutterbar, or counter clockwise to decrease.
10.14.2 Reel Clearance to Cutterbar: FD70
The finger to guard/cutterbar clearance with reels
fully lowered is 0.78 in. (20 mm) +/- 0.12 in.
(3 mm) measured at both ends of each reel,
and at the cutterbar flex locations with the
header in ‘full frown’ mode.
10.14.2.1 Clearance Measurement: FD70
CAUTION
Engage header lift cylinder stops before
working under header.
a. Raise header, and place two 6 in. (150 mm)
blocks just inboard of wing flex points.
b. Lower header fully, allowing it to flex into ‘full
frown’ mode.
c. Adjust fore-aft reel position so that back end of
cam disc is approximately between 4 and 5 on
the arm decal.
d. Measure clearance at ends of each reel.
NOTE
The reel has been adjusted at the
factory to provide more clearance at the
center of the reel than at the ends
(frown) to compensate for reel flexing.
e. Measure the clearance at both flex locations.
(continued next page)
CUTTERBAR
6 INCH BLOCKS
LEVEL GROUND
REEL
TAKE MEASUREMENTS 6 PLACES
TURN B
CLOCKWISE
TO DECREASE
CLEARANCE
A
B
LOOKING UP AT
ARM
UNDERSIDE
D
C
CLOCKWISE