Operator`s manual

SECTION 10. MAINTENANCE AND SERVICING

Form 169006 203 Revision D

10.14.10 Reel Drive Motor: D60, FD70

DANGER

To avoid bodily injury from fall of raised reel,

always engage reel props before going under

raised reel for any reason.

10.14.10.1 Removal: Drive Motor

a. Lower header, raise reel, and engage reel props.

b. Remove reel drive cover. Refer to Section

10.14.5 Reel Drive Chain: D60, FD70.

c. Loosen chain, and remove drive sprocket (A).

Refer to Section 10.14.7 Reel Drive Sprocket:

D60, FD70.

d. Disconnect hydraulic lines (B) at motor. Cap or

plug open ports and lines.

e. Slide motor mount (C) so that attachment bolts

(D) are exposed in holes (E) and slots (F) in back

plate.

f. Remove four nuts and bolts (D), and remove

motor.

10.14.10.2 Installation: Drive Motor

Refer to illustrations opposite.

a. Position hydraulic motor on motor mount (C) and

install four countersunk bolts (D) through holes

(E) and slots (F) in chain case into mount.

Torque to 75 ft·lbf (102 N·m).

b. Re-attach hydraulic lines (B) to motor.

c. Install sprocket (A) onto motor shaft, and install

chain. Refer to Section 10.14.7 Reel Drive

Sprocket: D60, FD70.

d. Re-attach reel drive cover. Refer to Section

10.14.5 Reel Drive Chain: D60, FD70.