Operator`s manual

SECTION 10. MAINTENANCE AND SERVICING
Form 169006 219 Revision D
10.17.2 Interval Maintenance
INTERVAL SERVICE
FIRST USE
Refer To Section 10.17.1 Break-In Inspections (previous page).
100 HOURS OR
ANNUALLY *
1. Check Wobble Box Mounting Bolts.
2. Check Wobble Box Lubricant Level.
3. Check Sickle Drive Belt Tension.
4. Check Transport Wheel Bolt Torque
(Option).
5. Check Reel Tine To Cutterbar
Clearance.
6. Check Reel Drive Chain Tension.
7 Check Auger to Pan, and Feed
Draper Clearance.
8. Check Gearbox Lubricant Level.
9. Grease Flex Header Lower Links.
10. Grease Float Spring Tensioners.
11. Grease Reel Drive Chain.
12. Grease Upper Cross Auger RH Support
(Option).
13. Grease Auger Bearing.
14. Grease Auger Drive Chain.
15. Grease Auger Driveshaft Bearings.
16. Grease Anti-Vibration Pivots.
17. Grease Float Pivots.
18. Lubricate Hydraulic Couplers.
19. Check Draper Seal.
END OF
SEASON
Refer To Section 9.10 STORAGE.
10 HOURS OR
DAILY
1. Check Hydraulic Hoses and Lines For Leaks.
2. Check Stabilizer/Transport Wheels Tire Pressure.
3. Check Sickle Sections, Guards, and Hold-Downs.
4. Oil Sickle (Except In Sandy Conditions).
25 HOURS
1. Check Hydraulic Oil Level at Reservoir.
2. Grease Sickle Head.
50 HOURS
1. Grease Sickle Drive Shaft Bearings (Double Knife).
2. Grease Driveline and Driveline Universals.
3. Grease Draper Roller Bearings.
250 HOURS OR
ANNUALLY *
1. Grease Transport Axle Pivot Bushings (Option).
2. Grease Split Reel U-Joint.
3. Grease Flex Header Bellcrank Linkage.
4. Grease Upper Cross Auger Center Support (30 FT and Up - Option).
5. Grease Auger Pivots.
6. Change Hydraulic Oil Filter.
7. Check Draper Seal.
500 HOURS OR
ANNUALLY*
1. Grease Transport/Stabilizer Wheel Hub Bearings.
2. Grease Reel Shaft Bearings.
3. Check Draper Seal.
4. Check Gearbox Chain Tension.
1000 HOURS OR
3 YEARS
1. Change Wobble Box Lubricant.
1500 HOURS OR
3 YEARS
1. Change Hydraulic Oil.
2. Change Gearbox Lubricant.
* IT IS RECOMMENDED THAT ANNUAL MAINTENANCE BE DONE PRIOR TO START OF OPERATING
SEASON.