Operator`s manual

SECTION 12. OPTIONS AND ATTACHMENTS
Form 169006 234 Revision D
12 OPTIONS AND
ATTACHMENTS
See your MacDon Dealer for availability and
ordering information.
12.1 AUTO HEADER HEIGHT
CONTROLLER
For use in conjunction with Auto Header Height
Control option on Case, New Holland, John
Deere and AGCO combines, and with the Header
Float option on Lexion combines on Model D50
and D60 Harvest Headers. It is standard
equipment on the FD70 FlexDraper header.
This attachment includes a potentiometer that
sends a signal to the combine to allow
maintaining a consistent cutting height and
optimum adapter float as the header follows
ground contours.
Mounting hardware, electrical harnesses and
installation instructions are included.
12.2 KNIFE REVERSING KIT
Available as an attachment for use with combine
headers. The reversing kit attaches to the CA20
adapter hydraulics and allows the header knife
drive to be reversed which assists in unplugging
the knife.
Installation and adjustment instructions are
included with the kit.
12.3 FLOAT/ANGLE INDICATOR
Available as an attachment for use with D50 and
D60 Harvest Headers, and standard equipment
on FD70 FlexDraper headers.
This attachment indicates to the Operator the
float setting and header angle setting with the
hydraulic center-link system.
Mounting hardware, electrical harnesses and
installation instructions are included.
12.4 HYDRAULIC HEADER TILT
Available as an attachment for use with D50 and
D60 Harvest Headers, and standard equipment
on FD70 FlexDraper headers.
This system allows changing the header angle
from the Operator’s console without stopping the
machine.