Operator`s manual

SECTION 7.2 CASE IH 7010, 8010, 7120, 8120, 88 SERIES

Form 169006 30 Revision D

7.2 CASE IH 7010, 8010, 7120, 8120,

5088, 6088, 7088

7.2.1 Attachment

IMPORTANT

Some combine models require special

center-link components to ensure

clearance to the combine cab.

To avoid damage to your combine, lift

feeder slowly and check clearance

between cab and header center-link.

If clearance is inadequate, contact your

MacDon Dealer to order special center-

link components. Refer to Section 7.1.1

Center-Link Kit.

a. Slowly drive combine up to adapter until feeder

house saddle (A) is directly under the adapter top

cross member (B).

b. Raise feeder house slightly to lift adapter,

ensuring feeder saddle is properly engaged in

adapter frame.

CAUTION

Stop engine, and remove key from ignition

before leaving Operator's seat for any reason.

A child or even a pet could engage an idling

machine.

c. Lift lever (C) on adapter at left side of feeder

house, and push handle (D) on combine to

engage locks (E) on both sides of the feeder

house.

d. Push down on lever (C) so that slot in lever

engages handle to lock handle in place.

e. If lock (E) does not fully engage pin on adapter

when (C) and (D) are engaged, loosen bolts (F),

and adjust lock as required. Re-tighten bolts.

f. Connect combine hydraulic quick coupler to

receptacle (G) on adapter as follows:

1. Open cover (H).

2. Push in lock button (J), and pull handle (K) to

“full open” position.

(continued next page)