Operator`s manual

SECTION 7.3 CASE IH 2300, 2500 SERIES
Form 169006 35 Revision D
5. Tighten jam-nuts (J) when force is correct.
6. Install pin (E) as shown to secure latch
handle in “locked position”.
b. Remove combine header lift cylinder locks, and
lower header to ground.
c. Connect combine hydraulics to adapter as
follows:
1. Disconnect reel drive hoses (K) and (L)
(white discs) from combine and adapter
receptacles.
2. Connect hose (K) from combine to adapter
coupler (M).
3. Connect hose (L) from the adapter to the
combine coupler (N).
4. Remove plug from reel lift coupler (O) (black
disc) on combine.
5. Remove red dust cap from reel lift hose (P)
on adapter, and connect hose to combine
coupler (O).
6. Disconnect reel fore-aft hoses (Q) and (R)
(red discs) from combine and adapter
receptacles.
(continued next page)
N
K
L
M
P
Q
R
O
L
K