Operator`s manual

SECTION 7.3 CASE IH 2300, 2500 SERIES

Form 169006 36 Revision D

7. Connect hose (Q) from combine to adapter

coupler (S).

8. Connect hose (R) from the adapter to the

combine coupler (T).

d. Connect adapter electrical harness (U) to

combine electrical connector, and if applicable

connect AHHC wire harness at U1.

e. Open guard (V) at combine output shaft.

f. Rotate disc (W) on adapter driveline storage

hook, and remove driveline from hook.

g. Pull back collar on end of driveline, and push onto

combine output shaft (X) until collar locks. Close

guard (V).

h. If adapter is equipped with reel fore-aft/header tilt

selector, connect harness (Y) to combine.

i. Disengage both adapter float locks by moving

latch (Z) away from adapter, and moving lever (A)

at each lock to “lowest position”.

LOCK

UNLOCK