Operator`s manual

SECTION 7.3 CASE IH 2300, 2500 SERIES
Form 169006 39 Revision D
5. Re-install plug on combine coupler (Q).
6. Disconnect reel fore-aft hoses (R) and (S)
(red discs) from adapter and combine
receptacles.
7. Connect hose (R) from combine to combine
coupler (T).
8. Connect hose (S) from the adapter to the
adapter coupler (U).
WARNING
To avoid bodily injury or death from
unexpected start-up or fall of raised
attachment, stop engine, remove key, and
engage lift cylinder stop before proceeding
with hook-up.
j. Disengage adapter from combine with one
of the
following two methods depending on combine
model.
Latch System
1. Raise feeder house fully, and engage
combine header lift cylinder locks.
2. Remove pin (V), and lower latch handle (W)
(one on each side of feeder house) to
disengage latch (X).
3. Raise latch handle to “storage position”, and
secure with pin (V).
4. Proceed to step k. below.
Sliding Pin System
1. Raise handle (Y) on left side of feeder house
to retract pins (Z).
k. Lower feeder house until it disengages adapter
support.
l. Slowly back combine away from adapter.
Q
R
T
S
R
V
W
X
U
S
Y
Z