Operator`s manual

SECTION 7.4 JOHN DEERE 60, 70 SERIES

Form 169006 42 Revision D

7.4.2 Detachment

a. Choose a level area. Position header slightly

above ground. Stop engine, and remove key.

DANGER

To avoid bodily injury or death from fall of

raised machine, always engage lift cylinder

stops before going under header for any

reason. See your Combine Operator’s Manual

for instructions for use and storage of header

lift cylinder stops.

CAUTION

Stop engine, and remove key from ignition

before leaving Operator's seat for any reason.

A child or even a pet could engage an idling

machine.

b. Engage both adapter float locks by lifting lever (A)

at each lock until it latches into the “lock position”.

IMPORTANT

If slow speed transport wheels are

installed, header may be detached in

either Transport or Field mode.

If detaching with wheel in Field mode,

set wheels to storage or “uppermost

working position”. Otherwise header

may tilt forward so that re-attachment

will be difficult. Refer to Section 9.11.2

Cutting Height.

IMPORTANT

If stabilizer wheels are installed, set

wheels to storage or “uppermost

working position”. Otherwise header

may tilt forward so that re-attachment

will be difficult. Refer to Section 9.11.2

Cutting Height.

c. If adapter is equipped with reel fore-aft/header tilt

selector, disconnect harness (B), and store on

combine.

d. Open shield (C) on combine. Pull back collar on

driveline, and pull driveline (D) off combine output

shaft.

e. Slide driveshaft in hook (E) so that disc (F) drops

to secure driveshaft.

(continued next page)

LOCK

UNLOCK