Operator`s manual

SECTION 7.4 JOHN DEERE 60, 70 SERIES

Form 169006 43 Revision D

f. Disconnect hydraulic/electrical coupler (G) from

combine as follows:

1. Remove lynch pin (H), and slide lock (J) to

release handle (K).

2. Lift handle (K) to “full vertical position” to

release coupler (G) from combine.

3. Lift handle (L) on adapter, position coupler in

adapter at (M), and lower handle (L) to lock

coupler.

g. Push handle (K) toward feeder house to

disengage feeder house pin (N) from adapter.

h. Lower feeder house until saddle (O) disengages

and clears adapter support (P).

i. Slowly back combine away from adapter.