Operator`s manual

SECTION 7.6 CAT LEXION 400, 500 SERIES
Form 169006 48 Revision D
7.6 CAT LEXION 400, 500 SERIES
7.6.1 Attachment
a. Handle (A) on the CA20 adapter should be in
“raised position”, and pins (B) at bottom corners
of adapter retracted.
b. Slowly drive combine up to adapter until feeder
house is directly under the adapter top cross
member.
c. Raise feeder house to lift adapter, ensuring
feeder house posts (C) are properly engaged in
adapter frame (D).
d. Position header slightly off the ground.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
e. Remove locking pin (E) from adapter pin (B).
f. Lower handle (A) to engage adapter pins into
feeder house. Re-insert locking pin (E), and
secure with hairpin.
(continued next page)
B
A
B
E
B
E
A
C
D
C
D