Operator`s manual

SECTION 7.6 CAT LEXION 400, 500 SERIES

Form 169006 51 Revision D

7.6.2 Detachment

a. Choose a level area. Position header slightly off

the ground. Stop engine, and remove key

DANGER

To avoid bodily injury or death from fall of

raised machine, always engage lift cylinder

stops before going under header for any

reason. See your Combine Operator’s Manual

for instructions for use and storage of header

lift cylinder stops.

CAUTION

Stop engine, and remove key from ignition

before leaving Operator's seat for any reason.

A child or even a pet could engage an idling

machine.

b. Engage the adapter float locks by lifting lever (A)

at both locks until it latches into the “lock

position”.

IMPORTANT

If slow speed transport wheels are

installed, header may be detached in

either Transport or Field mode.

If detaching with wheel in Field mode,

set wheels to storage or “uppermost

working position”. Otherwise header

may tilt forward so that re-attachment

will be difficult. Refer to Section 9.11.2

Cutting Height.

IMPORTANT

If stabilizer wheels are installed, set

wheels to storage or “uppermost

working position”. Otherwise header

may tilt forward so that re-attachment

will be difficult. Refer to Section 9.11.2

Cutting Height.

c. If adapter is equipped with reel fore-aft/header tilt

selector, disconnect harness (B), and store on

combine.

d. Disconnect driveshaft (C) from combine.

e. Slide driveshaft in hook (D) so that disc (E) drops

to secure driveshaft.

(continued next page)

LOCK

UNLOCK