Operator`s manual

SECTION 7.7 NEW HOLLAND CR, CX

Form 169006 55 Revision D

g. Connect to receptacle on adapter as follows:

1. Open cover (J).

2. Push in lock button (K), and pull handle (L)

halfway up to “open position”.

3. Remove hydraulic quick coupler (H) from

storage plate on combine, and clean mating

surface of coupler.

4. Position coupler onto adapter receptacle (M),

and push handle (L) to engage pins into

receptacle.

5. Push handle (L) to “closed position” until lock

button (K) snaps out.

h. Attach combine electrical connector (N) to

adapter as follows:

1. Remove cover on adapter electrical

receptacle (O).

2. Remove connector (N) from combine.

3. Align lugs on connector (N) with slots in

adapter receptacle (O), and push connector

onto receptacle. Turn collar on connector to

lock it in place.

i. Rotate disc (P) on adapter driveline storage hook,

and remove driveline from hook.

j. Pull back collar on end of driveline, and push onto

combine output shaft (Q) until collar locks.

k. Disengage both adapter float locks by moving

latch (T) away from adapter, and moving lever (U)

at each lock to “lowest position”.

LOCK

UNLOCK