Operator`s manual

SECTION 8.1 D50, D60 HEADER AND ADAPTER

Form 169006 64 Revision D

e. Lower stand (F) by pulling spring loaded pin (G).

Release pin when stand at desired height.

f. Remove pin (H) from leg on both sides of

adapter.

g. Disconnect hook type hydraulic center-link as

follows:

1. Lift release (J) and latch it in “up position”.

2. Extend center-link cylinder to disengage hook

from header.

3. Prop up center-link with a pin (or equivalent

tool).

h. Disconnect eye type hydraulic center-link as

follows:

1. Operate center-link hydraulics until pin (K) is

loose.

2. Remove pin (K), and lift center-link clear of

bracket.

3. Replace pin (K), and secure with lynch pin.

i. Disconnect mechanical link as follows:

1. Remove pin (L) to release link. Replace pin.

NOTE

Feeder house may need to be raised or

lowered, or length of link adjusted, to

relieve load on link.

j. Disconnect knife and draper drive hydraulic

hoses. Install caps and plugs on fittings.

(continued next page)

QUICK DISCONNECTS SHOWN

DRAPER DRIVE

RETURN

ELECTRICAL

KNIFE DRIVE

CASE DRAIN

(DOUBLE KNIFE)