Operator`s manual

SECTION 8.1 D50, D60 HEADER AND ADAPTER

Form 169006 65 Revision D

k. If quick disconnects are installed, disconnect as

follows:

1. Line up slot (M) in collar with pin (N) on

connector.

2. Push collar toward pin, and pull connector to

disengage.

3. Install plugs or caps on hose ends

(if equipped).

l. Disconnect electrical connector by turning collar

counter clockwise, and pulling connector to

disengage.

m. Store and secure hoses on adapter.

n. Disconnect reel hydraulics at right side of

adapter. Install caps and plugs on fittings.

o. If multi-coupler is installed, disconnect as follows:

1. Push in lock button (O), and pul

l handle (P) to

release coupler (Q).

2. Push handle down until button (O) snaps out.

3. Store hoses over adapter frame.

p. Ensure header is on ground, or is supported by

wheels in transport mode or jack stand.

q. Slowly back combine away from header.

r. Re-insert pins (R) in legs of header.