Operator`s manual

SECTION 8.1 D50, D60 HEADER AND ADAPTER

Form 169006 66 Revision D

8.1.2 Assembly

The D50 and D60 Harvest Header can be

attached to the adapter from either Field

configuration or Transport configuration.

NOTE

Stabilizer/Transport wheels can be

used in combination with the stand to

support header.

a. Remove lynch pin, and remove pin (A) from each

header leg. Temporarily store in safe place for

re-installation.

b. If not installed, install vibration dampers on ends

of adapter arms as follows:

1. Locate damper (B) onto adapter arm (C).

2. Secure with spacer (D), bolt (E), washer, and

lock-washer.

c. Prop up center-link (F) (hydraulic shown) with pin

(or equivalent tool).

d. Lower combine feeder house so that adapter

arms (C) are aligned with header legs (G).

e. Slowly drive forward, again aligning adapter arms

and header legs.

f. Keep adapter arm (C) height just under the

header leg (G) to ensure adapter leg seats

properly in the header linkage supports.

IMPORTANT

Keep hydraulic hoses clear to prevent

damage when driving into header.

g. Continue forward until adapter arm contacts stop

in header leg. Raise adapter slightly.

(continued next page)

HOOK TYPE

EYE TYPE