Operator`s manual

SECTION 8.1 D50, D60 HEADER AND ADAPTER
Form 169006 67 Revision D
h. Connect hook type hydraulic center-link as
follows:
1. Extend hook (H), and remove prop under link
so that base of hook rests on pin (J).
2. Operate header angle hydraulics to retract
hook until it engages pin and self-latches.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
3. Shut down engine, and remove key.
4. Ensure hook (H) is securely attached.
5. Proceed to step k. in next column.
i. Connect eye type hydraulic center-link as
follows:
1. Shut down engine, and remove key.
2. Remove pin (K), and the prop under link.
3. Adjust length of link by operating header
angle hydraulics to align with header bracket.
4. Insert pin (K), and secure with lynch pin.
j. Connect mechanical center-link as follows:
1. Shut down engine, and remove key.
2. Remove pin (L) and the prop under link.
3. Adjust length of link by turning barrel (M) to
align with header bracket.
4. Insert pin (L), and secure with lynch pin.
k. Connect reel hydraulics matching coloured plastic
ties.
(continued next page)
H
J
K
K
L
M