Operator`s manual

SECTION 8.1 D50, D60 HEADER AND ADAPTER
Form 169006 68 Revision D
l. If multi-coupler is installed, connect as follows:
1. Push in lock button (N), and pull handle (O)
to “full open position”.
2. Clean couplers.
3. Position coupler (P) from combine onto
receptacle, and push handle (O) to engage
pins on coupler.
4. Push handle to “closed position” until lock
button (N) snaps out.
m. Secure header to adapter as follows:
1. Ensure adapter arm is properly located in
header leg (G). Re-install pin (A) in each leg
to lock header to adapter, and secure with
lynch pin.
2. Return stand (Q) to “storage position”, and
secure with pin (R).
n. Lower header to ground.
o. Tilt header to “almost full forward position” to
increase clearance under adapter feed draper.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
p. Raise reel, shut off engine, and remove key.
Engage reel props.
(continued next page)
N
O
N
O
P
Q
R
A
G