Operator`s manual

SECTION 8.2 FD70 FLEXDRAPER AND ADAPTER

Form 169006 72 Revision D

3. Rotate latch (D) with a 15/16 wrench on hex

(E) to raise feed deck so that bolt (F) can be

removed. Repeat for other side of feed

draper deck.

4. Rotate latches to lower adapter deck.

5. Remove chain (G) from hook. Rotate latch

back to original position, and re-install bolts

(F).

h. Engage the adapter float locks by lifting lever (H)

until it latches into the “lock” position.

NOTE

Stabilizer/Transport wheels can be

used in combination with the stand to

support header.

i. Lower stand (J) by removing pin (K). Re-install

pin when stand at desired height.

NOTE

45 FT header does not have a stand.

Use blocks at this location.

DANGER

To avoid bodily injury or death from fall of

raised machine, always engage lift cylinder

stops before going under header for any

reason. See your Combine Operator’s Manual

for instructions for use and storage of header

lift cylinder stops.

j. Disengage reel props, start engine, lower reel

and raise header fully. Stop engine, remove key,

and engage combine lift cylinder locks.

k. Remove bolt (L), washer, and spacer from leg on

both sides of adapter. Retain for later

re-installation.

l. Disengage lift cylinder locks, and lower header to

blocks, and allow the header wings to go into full

frown mode. Stop engine, and remove key.

CAUTION

Stop engine, and remove key from ignition

before leaving Operator's seat for any reason.

A child or even a pet could engage an idling

machine.

(continued next page)

LOCK

UNLOCK