Operator`s manual

SECTION 8.2 FD70 FLEXDRAPER AND ADAPTER

Form 169006 73 Revision D

m. Disconnect hook type hydraulic center-link as

follows:

1. Lift release (M), and latch it in “up position”.

2. Extend center-link cylinder to disengage hook

from header. Stop engine, and remove key.

3. Prop up center-link with a pin (or equivalent

tool).

4. Go to step o. in next column.

n. Disconnect eye type hydraulic center-link as

follows:

1. Remove pin (N), and lift center-link clear of

bracket.

2. Replace pin (N) and secure with lynch pin.

NOTE

Feeder house may need to be raised or

lowered, or length of link adjusted to

relieve load on link.

o. Disconnect knife and draper drive hydraulic

hoses.

p. If quick disconnects are installed, disconnect as

follows:

1. Line up slot (O) in collar with pin (P) on

connector.

2. Push collar toward pin, and pull connector to

disengage.

3. Install plugs or caps on hose ends (if

equipped).

q. Disconnect electrical connector by turning collar

counter clockwise, and pulling connector to

disengage.

r. Store and secure hoses on adapter.

(continued next page)

DRAPER DRIVE

RETURN

ELECTRICAL

KNIFE DRIVE

CASE DRAIN

(DOUBLE KNIFE)