Operator`s manual

SECTION 9. OPERATION
Form 169006 84 Revision D
9.10 STORAGE
Do the following at the end of each operating
season:
a. Clean the header thoroughly.
CAUTION
Never use gasoline, naphtha or any volatile
material for cleaning purposes. These
materials may be toxic and/or flammable.
CAUTION
Cover cutterbar and sickle guards to prevent
injury from accidental contact.
b. Store the machine in a dry, protected place if
possible. If stored outside, always cover with a
waterproof canvas or other protective material.
c. If machine is stored outside, remove drapers and
store in a dark, dry place.
NOTE:
If drapers are not removed, store
header with cutterbar lowered so
water/snow will not accumulate on
drapers. This accumulation of weight
puts excessive stress on drapers and
header
d. Lower header onto blocks to keep cutterbar off
the ground.
e. Lower reel completely. If stored outside, tie reel to
frame to prevent rotation caused by wind.
f. Repaint all worn or chipped painted surfaces to
prevent rust.
g. Loosen drive belts.
h. Lubricate the header thoroughly, leaving excess
grease on fittings to keep moisture out of
bearings. Apply grease to exposed threads,
cylinder rods and sliding surfaces of components.
Oil sickle components to prevent rust.
i. Check for worn or broken components and repair
or order replacement from your MacDon Dealer.
Attention to these items right away will save time
and effort at beginning of next season.
j. Replace or tighten any missing or loose
hardware. Refer to Section 10.3.1
Recommended Torques.