Installation Instructions

FORA LED Security Light with PIR Motion Sensor120V

INSTALLATION INSTRUCTIONS

FL2-3CCT

MOTION SENSOR OPERATION:

See Figure 2 above for reference.

1. Switch the TIME/TEST switch in the TEST position to disable the photocell and allow light to come on during daylight hours.

2. Rotate the RANGE knob fully clockwise to maximum RANGE.

3. Aim the MOTION SENSOR HEAD level at least 10 Degrees downward an across the trac pattern you want to detect.

4. Test Motion detection zone by walking across the pattern in the targeted coverage area. A red LED indicator light in the motion head will ﬂash

when motion is detected and the lights will come on for approximately (40 seconds). Move to a dierent spot in the area to be tested and stop

all motion for about 8 seconds. The lights should turn o. Start walking again to see if your motion is detected in the new spot. Move further

away to check the distance and adjust range to your desired location.

5. SET ON-TIME: When you are satisﬁed with the area of coverage, shift the TIME/TEST switch to set the ON time. The TIME setting switch will

let you adjust the time that the light will stay on after motion is detected from approximately 1 to 10 minutes.

6. MANUAL OVERRIDE METHOD: To disable the motion and keep the light continuously on in the darkness, ﬂip the wall switch o and back on

within 3 seconds. If you leave the light on all night, it will automatically turn o at dawn and reset to Security Mode.

CARE AND MAINTENANCE:

1. For cleaning, use a soft, dry or damp cloth. Do not use harsh chemicals or abrasives.

PhotocellRange Knob

Time/Test

Switch

FIGURE 2