Installation Guide

REV 0 - 1709011350

L-C2-444

Model# 24-IL-C

30-IL-C

36-IL-C

Grill Series Liner Model

24NBL, 24NBT

24-IL-C

30NBL, 30NBT 30-IL-C

36NBL, 36NBT 36-IL-C

Table 1 - Models available

SPECIFICATIONS

Fig. 1-1 Installation orientation

Cut-out

GRILL INSULATING LINER

IMPORTANT INFORMATION

Read these instructions and the safety and installation sections

of the grill owner's manual before liner installation.

The insulating liner comes pre-assembled and ready to install.

FOR YOUR SAFETY, the enclosure must provide openings for

drainage, replacement air, and cross-ventilation of any storage

area exposed to possible leakage from gas connections, the

unit, or propane cylinders.

This liner is only for installation in an enclosure constructed

of combustible materials and a NON-COMBUSTIBLE

countertop.

All additional enclosure requirements, safety guidelines,

and any other requirements found in your grill owner's

manual MUST BE FOLLOWED.

The insulating liner is designed to be supported from the

countertop using the liner hangers. S

ee Fig. 1-1.

Note: Framing the cut-out with side walls, a rear wall, and a

base is permitted.

See your grill owner's manual for all overall enclosure

requirements.

See sections on following pages regarding cutout

dimensions, and countertop overhang and substrate

considerations. Then proceed to INSTALLATION.

INSTALLER: Leave these instructions with consumer.

CONSUMER: Retain for future reference.

Support

using liner

hangers

ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746

PAGE 1
GRILL INSULATING LINER Model# 24-IL-C 30-IL-C 36-IL-C INSTALLER: Leave these instructions with consumer. CONSUMER: Retain for future reference. SPECIFICATIONS IMPORTANT INFORMATION Read these instructions and the safety and installation sections of the grill owner's manual before liner installation. The insulating liner comes pre-assembled and ready to install.
PAGE 2
SPECIFICATIONS (cont.) CUTOUT DIMENSIONS 24NBL, 24NBT 24-IL-C 30NBL, 30NBT 30-IL-C 36NBL, 36NBT 36-IL-C 9" 9" 9" B Side to side cut-out 28 5/8" 34 5/8" 40 5/8" C Front to back cut-out * 21 5/8" 21 5/8" 21 5/8" D Liner flange width cut-out † 29 5/8" 35 5/8" 41 5/8" Grill series Insulating liner model A Countertop to unit bottom cut-out * Includes any substrate at front wall of enclosure (in the areas the liner flanges are to sit flush against). See SUBSTRATE section on next page.
PAGE 3
SPECIFICATIONS (cont.) Substrate When adding any substrate to the enclosure front wall (including tiles, stone, etc.), make allowance for: Substrate Behind Liner Flange Substrate Alongside Liner Flange Substrate + countertop "front to back" cutout must equate to Dim. C (see previous page) when the substrate sits flush behind the liner flanges. Any additional substrate alongside the liner flanges does not need to be considered in Dim. C (see previous page).
PAGE 4
NOTES PAGE Please use this page to record any information that you may want to have at hand.