Manualshelf

Instruction Guide

ManualsBrandsAmerican Outdoor Grill ManualsBarbecue36 Inch Grill Insulating Liner for AOG Built-In Grills
1234
1
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
IMPORTANT INFORMATION & TECHNICAL DATA
Read these instructions and the safety and installation portions of the grill instructions before liner installation.
The insulating liner kit includes the pre-assembled liner, two support hangers, and a heat shield. Liner
cutout dimensions are given in Table 1. A nominal
1
/
16
" gap around the back and sides of the liner is
recommended for ease of installation. A minimum of 5" from combustible material is required directly
below the top of the support hangers/Stud A, to allow for clearance of the heat shield (See Fig. 2-2). If
a complete combustible shelf is installed beneath the heatshield, it must contain two ventilation cutouts.
The cutouts must be located directly below the right hand and left hand ends of the heatshield. Reference
Table 2 for dimensions. If the countertop thickness exceeds 2", new screw holes must be made in the
support hangers.
Countertops and cabinet faces made of combustible material, such as wood, Formica, and Corian, can
extend up against the outside walls of the insulating liner and be joined by a bead of silicone sealer rated
for 400° or higher, as shown in Fig. 3-1. Never build over the insulating liner with combustible materials, as
this will interfere with the grill hanger.
The cabinet base must include 100 sq. in. of ventilation within 12" of the fl oor. Refer to the grill safety
precautions and installation instructions for additional propane gas venting requirements (if applicable).
Replacement parts may be obtained from your nearest American Outdoor Grill dealer. For assistance in
locating a dealer, you may contact the factory at the address listed below.
REV 6 - 0908120904
L-C2-21509
AMERICAN OUTDOOR
GRILL INSULATING
LINER INSTRUCTIONS
AMERICAN OUTDOOR GRILL
Grill
series
Liner
Model
Height Width Depth
24" 24-IL 8
5
/
8
" 30
1
/
4
" 22
1
/
4
"
30" 30-IL 8
5
/
8
" 36
1
/
4
" 22
1
/
4
"
36" 36-IL 8
5
/
8
" 42
1
/
2
" 22
1
/
4
"
Table 1 - Enclosure cutout dimensions (for liner)
Grill series Width Depth
24" 6
1
/
4
" 13
1
/
8
"
30" 6
1
/
4
" 13
1
/
8
"
36" 6
1
/
4
" 13
1
/
8
"
Table 2 - Combustible shelf cutout dimensions
American Outdoor Grill • P.O. Box 4053 • La Puente, CA 91747 • www.americanoutdoorgrill.com

Summary of content (4 pages)