Technical information

INSTALLATION

3. Cut penetration for the control panel and cables

Refer to the assembly drawing attached to the back of this manual to find the location of the control panel. Establish

the location of the controller on the cabinet and cut a penetration of 7-1/2” x 3-1/2” to accommodate the cables and

the cable duct.

4. Install air deflectors

Install the air deflectors on the top corners (above the fan and coil frames) using the provided self-taping stainless

steel screws (see DRAWING B.3.1)

B.3. Single Unit Installation AP40BC250-12 And BCCP-1

1. Install the coil assembly frame

Insert the evaporation coil assembly frame into the cabinet at the location indicated in the assembly drawing attached

to the back of this manual. The evaporator filter must face the interior of the box (see DRAWING B.3.4). Push the

assembly tight to the side wall leaving ¼” space at the front and rear panels.

2. Adjust the seal brackets on the evaporation coil frame

Remove the filter side trims to have access to seal brackets (see DRAWING B.3.1 and DRAWING B.3.2), tighten the

wing nuts to seal the space between the coil assembly frame and the cabinet wall on both sides of the coil assembly

frame.