Technical information

PROGRAMMING
24
D. Programming The Controller
WARNINGS!
Read and carefully follow all of the instructions in this manual before attempting to install this equipment.
Installation must be performed by a qualified Service Agency approved and authorized by American Panel
Corporation. Doing otherwise may void the warranty.
Any changes made to the equipment without authorization from the factory will void the warranty.
All American Panel Corporation blast chillers are initially programmed at the factory. These settings may
be considered standard for AP40BC250-12, AP40BC250-2-12, BCCP-1, BCCP-2, and BCIP units. However, the
customer may change any of these settings as indicated by necessity.
D.1. Keyboard
Keys
ON/OFF & START/STOP CYCLE KEYS
ON/OFF SOFT CYCLE
START/STOP HARD CYCLE
SHOCK CYCLE (N/A)
PROGRAMMING KEYS
AUTOMATIC CYCLE
UP
MANUAL CYCLE
DOWN / THAW
UV LIGHT CYCLE
SELECT DEFROST CYCLE
ENTER PRINT
HEAT PROBE CYCLE
D.2. Key Combinations
 Initial Programming state – to initially set the device
o With the display reading "OFF", press and hold
(“START/STOP”) for 5 seconds
 Cycles programming state – to initially set the cycles
o With the display reading "OFF", press
(“SELECT”) for 1 second
 Recipe name programming state – to enter recipe names