Technical information

PROGRAMMING
25
o With the display reading "OFF", press (“A”) for 10 seconds
 Load default values state – to load the standard parameters
o With the display reading "OFF", press
(”UP”) for 10 seconds
 Clear events memory state – to clear obsolete data
o With the display reading "OFF", press
+ (”UP”+”DOWN”) for 10 seconds
 Ready To Go state – in order to start a cycle
o If the controller is not "OFF", press
“ON/OFF” once.
D.3. Programming Modes
There are two programming modes to be covered:
Initial Programming - settings like year, month, date, time, and several other parameters.
Parameter Programming - settings that control the chilling cycles.
To program the controller the customer can either use the control panel at the unit, or the PC application.
D.4. Initial Programming
The initial configuration of the system can be performed in Initial Programming mode. This includes setting the
current year, month, date and time, as well as several other parameters.
Note: During the programming steps, any delay longer than 20 seconds before pushing the next button will cause the
controller to revert to “OFF” state and the display will show: OFF. TO AVOID THIS, THE FOLLOWING INSTRUCTIONS
SHOULD BE CAREFULLY REVIEWED AND THE DESIRED SETTINGS SHOULD BE DETERMINED BEFORE
PROCEEDING.
If the control panel goes to OFF state, programming mode will have to be restarted.
Note: During programming, pressing and holding
or button for more than two seconds will increase the value
changing speed.
D.4.1. Initial Programming Procedure And Parameters
NOTE: Initial programming is preset at the factory. Use this section only if changes are desired. If no
changes are to be made, skip to Page 29 (D.5 Parameter Programming).
a. With the display reading "OFF", press
("START/STOP") for a few seconds.
b. To change the language, press or then
press
.
ENGLISH
Blinks
c. Enter the default password by pressing, in order, the
and buttons.
INITIAL PROGRAMMING
ENTER PASSWORD:
***
INITIAL PROGRAMMING
SELECT LANGUAGE
ENGLISH
OFF