Technical information

PROGRAMMING
26
If the entered password is wrong the display will show, for 3
seconds:
Then the controller will go back to step c.
TRY AGAIN
Blinks
NOTE: If a wrong password is introduced three times the controller will go into “OFF” state.
During the password typing,
button can be used to delete one or more characters.
d. If you do not wish to change the password, press .
To change the default password, press
or for
"YES" then press
.
The password will always be a combination of three of the six available cycles:
("SOFT", "HARD", "SHOCK", "DEF", "UV", "HEAT PROBE").
Type the new password, then press
.
Be sure to remember the new password and keep a record of it in a safe place.
e. To change the year, press or then press
.
2006(year)
Blinks
f. To change the month, press or then press
.
07(month)
Blinks
g. To set the day, press or then press .
03(day)
Blinks
h. To set the hour, press or (be sure to
continue to press the buttons until the hour and "AM" or
"PM" show correctly) then press
.
10(hours)
Blinks
i. To set the minutes, press or then press
.
25(minutes)
Blinks
j. To change the number of probes, press or
then press
.
1 Blinks
INITIAL PROGRAMMING
WRONG PASSWORD
TRY AGAIN
INITIAL PROGRAMMING
AIR PROBES NUMBER?
1
INITIAL PROGRAMMING
SET TIME
10:25 AM
INITIAL PROGRAMMING
SET TIME
10:25 AM
INITIAL PROGRAMMING
SET DAY
03
INITIAL PROGRAMMING
SET MONTH
07
INITIAL PROGRAMMING
SET YEAR
2006
INITIAL PROGRAMMING
CHANGE PASSWORD?
NO