Technical information

PROGRAMMING
28
If you selected YES at the previous step, the next steps will allow you to setup the thaw cycle. If you
selected NO, skip to step y.
s. To change the final temperature of the food to be thawed,
press
or then press .
38 Blinks
t. To change the maximum air temperature during the thaw
cycle, press
or then press .
50 Blinks
u. To change the minimum air temperature during the thaw
cycle, press
or then press .
42 Blinks
v. To change the maximum air temperature during the hold
cycle, press
or then press .
42 Blinks
w. To change the minimum air temperature during the hold
cycle, press
or then press .
35 Blinks
x. To change to YES or NO, press or then
press
.
NO Blinks
For YES, the display will show:
The P.C. baud rate should be left at 38400.
y. Press
to skip.
38400
Blinks
z. To change the number (between 01 & 32), press or
then press .
01 Blinks
aa. To change to YES or NO, press or then
press
.
NO Blinks
For YES, the display will show:
The printer baud rate should be left at 1200.
However, to make a change:
bb. Press
or then press .
1200 Blinks
INITIAL PROGRAMMING
THAWING CYCLE
HOLD LOW AIR
35 °F
INITIAL PROGRAMMING
THAWING CYCLE
HOLD HIGH AIR
42 °F
INITIAL PROGRAMMING
THAWING CYCLE
MIN AIR TEMP
42 °F
INITIAL PROGRAMMING
THAWING CYCLE
MAX AIR TEMP
50 °F
INITIAL PROGRAMMING
THAWING CYCLE
TARGET FOOD TEMP
38 °F
INITIAL PROGRAMMING
PRINTER BAUDRATE
1200
INITIAL PROGRAMMING
PRINTER CONNECTION?
NO
INITIAL PROGRAMMING
CHILLER NETWORK ID
# 01
INITIAL PROGRAMMING
PC BAUDRATE
38400
INITIAL PROGRAMMING
PC CONNECTION?
NO